Before the abundance of highly concentrated forms of cannabis, we had to get creative to elevate highs to levels the average pipe and bong couldn’t. The only two ways to accomplish this were with the help of kief which could take a long time to accumulate and the gravity bong. There are all-glass versions you can buy that are safer to smoke. However, a homemade gravity bong typically consists of cut up plastic bottles and an aluminum foil bowl. As a result, you shouldn’t re-use them or rely on one as a regular method of consumption. In case you want a potent blast from the past or you feel like turning your smoke session into a DIY project, we’ll show you how to make a gravity bong.To get more news about cheap big bong, you can visit sharebongs.com official website.

A bucket bong usually consists of the bottom half of a 2 liter of soda and the top half of a smaller plastic bottle. However, any sizes will do as long as the bottom is larger than the top.

The bottom half is filled with water and the top half will consist of both the bowl and mouthpiece. Despite the name, gravity doesn’t play much of a role in the function of a bucket bong. Instead, a high-pressure environment is created as the top half is forced into the bucket of water. Then, the flame of your lighter and smoke will be vacuumed into the bottle as you pull it up out of the water.Clearing a bucket bong is easier than a waterfall bong because the pressure in a bucket bong helps to force all of the smoke out of the bottle and into your lungs as soon as possible.

Waterfall Bong

The other style of gravity bong is called a waterfall bong. It will only require the use of one large plastic bottle. It actually uses gravity and gravity alone to milk the bottle for you.

The top consists of both the bowl piece and the mouthpiece like on a bucket bong. The bottom is just your standard bottle with a hole at the bottom. When it’s time to smoke, the bottle gets filled with water while the hole is plugged. Then the cap with a bowl full of weed is put back on. Removing your finger will allow gravity to pull all of the water out of your bong like a waterfall.

Make sure the lighter is sparked above the bowl before you remove your finger from the hole. Then watch the water pour as smoke takes its place.

The waterfall experience saves your lungs from the effort of milking the bong. However, clearing the bong is on you.If you’re using a homemade gravity bong with the bucket style, you’ll need to cut some plastic. Use a box cutter or scissors to carefully cut the bottom of the smaller bottle off. The larger the top half is, the more smoke it can hold.

Cut the larger bottle in half and toss the top out so that you’re left with a plastic bucket. The bucket needs to be deep enough for the top to be submerged down to the neck without touching the bottom.

Finally, carve a hole in the cap with a box cutter or scissors and use the aluminum foil to form a bowl. Poke holes so the smoke can travel into the bottle. If you completed every step we mentioned, your gravity bong is ready for use.First, fill the bottom half with water but not all the way to the top. You don’t want it to overflow when you submerge the top half. Then, remove the cap and fill the bowl with ground up weed.

The next step is where some people make rookie mistakes. Submerge the top half down to the neck in water with the cap still aside. If the filled bowl is screwed on as you push the top half into the water, the weed will go flying out everywhere.